Cloning hard drive with Norton Ghost

Imagine you are a computer technician involved in a project to build a network at the cafe with a computer server and the client computer 9. You assemble the computer one by one, after that you also install them one by one. Think of time assembling and installing the computer you need to take 4 hours, this means you need 40 hours to assemble and install 10 computers. Wow ..... Just imagine, doing the repetitive nature of time will make us bored. Then what is the solution? 

Norton Ghost is the software used to clone HDD on a computer. Because of this clone, so the host computer to other computers in exactly the same. So, what are the steps?
1. Perform a complete installation in a hard drive, be it operating system and all software needed and of course the driver.
2. Replace the hard disk to be used as a child on the CPU (assuming the motherboard and hard drive are now using a SATA interface, so no need to move the jumper again.)
3. Restart the computer, after the live run Norton Ghost with the way the Start-All Programs-Norton Ghost 2003 Norton Ghost.
4. In Source select disk1 and disk2 in our chosen Destination. Source is the source or the parent of our hard disk to be cloned. Destination is the child of a hard drive cloning. This means we will move all the contents from disk1 to disk2.
5. After memnentukan hard disk to be cloned click "Next".
6. On the "Important information" we should read carefully what will happen after we click "Next" is Norton Ghost will restart the computer and perform the clone, and the long process of cloning from the number of data depending on Harddisk1 (Source).
7. When all was ready for cloning hard drive, then "Next" and then click "Run Now" and "OK" to perform the process of cloning a partition that is determined to complete.
8. After the cloning process is complete, remove the disk2 (destination) to be installed on another computer.
A few from my brief tutorial. Good luck. :)